EX2 Elevator Lever Replacement HI0414375 for Hirobo  [HI0414375]

EX2 elevator lever overview

This elevator lever is supplied as a direct replacement component for the EX2 series elevator linkage on Hirobo radio-controlled helicopters. It transfers servo motion into elevator surface movement and is intended for model rotorcraft maintenance and setup.

The text emphasises fitment and practical setup rather than marketing language. Fit this lever when a bent or worn unit needs replacing to recover predictable elevator response. When refitting, observe linkage geometry, servo arm position, and neutral trim to keep hover stability and precise pitch control.

Installation is straightforward for hobbyists familiar with small-scale helicopters: remove the original lever from the rotor head, carry over any reusable bearings or hardware, fit the replacement lever, and confirm free movement and correct centring prior to first flight. Set clevis positions and servo endpoints to match original throw and avoid binding through collective and cyclic ranges.

After installation, inspect pivot points regularly; check for play and ensure retained hardware is tightened to the original guidance. Make small tuning adjustments and validate behaviour in a restrained hover before applying full cyclic authority.

A service replacement lever for routine RC helicopter maintenance to restore predictable elevator control.