EMBLA SZM2 Mixing Arm Tail Link - HI0304113 by Hirobo  [HI0304113]

Replacement tail mixing arm for EMBLA SZM2

This arm (HI0304113) is made to fit EMBLA SZM2 helicopters and converts servo motions into the combined movements required for tail control.

Fit this replacement when the original arm shows wear or damage to restore proper tail mixing and trim behavior. Confirm mechanical alignment against your model's linkage layout before final installation.

Installation notes: remove the worn link, compare geometry with the replacement, and secure fasteners using the original torque and safety procedures specific to EMBLA SZM2 assemblies. After fitting, check servo endpoints and test tail mixing in a low hover to verify correct directional response and fine-tune trim.

Maintenance tip: routinely inspect pivot points and fasteners for play, and renew any worn connectors to preserve precise tail response and avoid unstable flight behavior.