Embla SZM2 Lightweight Stabilizer Blade - HI0304105 by Hirobo  [HI0304105]

Swift tail stabilizer for Embla SZM2

This is an RC-scale stabilizer blade specified by the Hirobo model HI0304105, created for the EMBLA SZM2 range. It is the light variant of a tail stabilizer blade intended for Embla SZM2-class models that use the same part designation.

The component's purpose is to improve tail rotor stability and provide a consistent control surface for trimming and tuning tail response. The description targets hobbyists who carry out bench setup and field adjustments, with emphasis on how the blade alters yaw damping and small-signal behaviour.

Installation notes: the blade attaches to the stabilizer linkage and tail rotor assembly using existing Embla SZM2 mounting points. When swapping the stabilizer blade, check alignment with the tail boom and tighten fasteners in line with the model's standard hardware practice. After fitting, make incremental trim adjustments and hover checks to verify the response before full-power flying.

Tuning guidance: apply small trim changes to observe effects on tail oscillation and heading hold, then log settings for repeatability. The light designation indicates lower mass versus heavier versions, which may reduce passive damping and necessitate retuning tail gains or pitch curves on the helicopter's flight controller.