Embla EB Tail Holder Replacement - Hirobo HI0304158  [HI0304158]

Replacement Tail Holder for Embla EB

This Hirobo HI0304158 tail holder is offered as an RC-scale replacement component for Embla EB series tail assemblies. It functions as a fixed mounting point in the tail section to keep the tail boom and linkage aligned during normal operation and maintenance.

Made for straightforward swap-in replacement, the holder installs into the existing tail framework and uses the helicopter's original mounting points. The paragraph focuses on fit and function rather than specific hardware details, which are not listed in the source.

For installation and setup, a correctly seated tail holder helps preserve tail pitch and yaw geometry, reducing repeat trim work after reassembly. Follow standard RC assembly practices when reinstalling tail components and verify alignment before test flights.

This replacement is intended for maintenance and component replacement on Embla EB helicopters, providing a direct fit where original tail holders are required.