This RC-scale aluminum gear box mount is made for the Element Enduro platform and carries a gun metal finish. It is intended to replace or upgrade the stock gearbox mounting interface to provide a rigid, machined surface that improves drivetrain alignment and chassis response during trail duties.
Installation is straightforward for hobbyists used to trail truck service: remove the original mount from the Enduro gearbox area, transfer existing fasteners and bearings where required, and secure the new aluminum mount to the factory mounting points. The item is defined by material and finish rather than a dedicated hardware kit; verify your chassis fit and retained hardware compatibility before final assembly.
From a tuning perspective this mount functions as a chassis-level hop-up: increasing stiffness at the gearbox attachment point can reduce flex under load and alter motor, spur and pinion loads along with suspension feedback. Expect modest handling changes rather than dramatic gains and confirm alignment and clearances during initial testing.
Copyright © 2008-2026 rcjaz.ca All rights reserved
