EDS 160140 Arm Reamer 4.0 X 120mm Precision Tool  [EDS-160140]

EDS 160140 - Arm Reamer 4.0 X 120mm
Price:
CAD$15.33
Brand:
EDS
Model:
EDS-160140
Condition:
Brand New
Write a review

Accurate Reaming for Suspension Arms

The EDS 160140 Arm Reamer is an essential workshop tool for RC enthusiasts who demand tight tolerances. With a 4.0mm diameter and 120mm length, this reamer helps produce clean, concentric holes in suspension arms to improve fitment and reduce binding.

Engineered for Fine Tuning

This tool is built to give you the control needed when adjusting suspension components. The 4.0mm cutting size creates consistent, round holes while the 120mm shaft reaches into deeper or awkward placements common on scale models.

Routine Maintenance and Setup

Keep suspension linkages and arm mounts moving freely by using the EDS 160140 Arm Reamer as part of your maintenance routine. It simplifies enlarging or cleaning out worn holes so parts run smoothly and reliably.

Which types of suspension arms work best with the EDS 160140?

Many plastic and composite suspension arms benefit from a properly sized reamer to restore roundness and alignment. Always check on a spare piece if you are unsure about material compatibility.

How should I hold and use the arm reamer for safe, accurate results?

Secure the arm in a soft vise or clamp, feed the 4.0mm reamer slowly, and rotate evenly to prevent wobble. Remove debris between passes to maintain a clean cutting surface.

Can the 120mm length reach recessed or hard to access holes?

The 120mm shaft gives extra reach compared with shorter tools, making it easier to work on deeper mount points or tight chassis areas. Take care to support the workpiece when reaming at depth.

Copyright © 2008-2026 rcjaz.ca All rights reserved