EDS 160135 Arm Reamer 3.5 x 120mm Setup Tool  [EDS-160135]

EDS 160135 - Arm Reamer 3.5 X 120mm
Price:
CAD$15.60
Brand:
EDS
Model:
EDS-160135
Condition:
Brand New
Write a review

Fine tuning with EDS 160135 Arm Reamer

The EDS 160135 Arm Reamer is a straightforward setup tool for RC hobbyists who need accurate holes in suspension arms. Its 3.5mm cutting diameter and 120mm length make it suitable for opening or cleaning pivot points so parts fit with minimal slop.

Accurate suspension hole control

Use the reamer to enlarge or true up suspension arm holes to the exact size required. Correctly sized pivot holes help preserve alignment and reduce excess play so steering and suspension behaviour stays consistent over many runs.

Ergonomic feel and lasting build

The reamer is finished for regular workshop use, with a handle shaped for controlled turning and a shaft built to retain its cutting profile. It is meant for routine tuning and maintenance without sacrificing precision.

Can I use the reamer on plastic and composite arms?

Yes. The EDS 160135 works well on common suspension plastics and nylon composites; take light passes to avoid overcutting softer materials.

How do I keep the hole centred while reaming?

Mark the pivot hole and start with a pilot drill or guide, then turn the reamer steadily. Use a bench clamp or jig to prevent wobble for a true, round hole.

Is the length suitable for deep or awkward arms?

The 120mm shaft gives enough reach for most suspension arms and arms with recesses, while still being easy to control by hand.

Copyright © 2008-2026 rcjaz.ca All rights reserved