EAGLE-3 E3 Elevator Shaft Replacement HI0414318 by Hirobo  [HI0414318]

Service elevator shaft for EAGLE-3 E3

This Hirobo HI0414318 replacement elevator shaft is supplied as a direct spare for the EAGLE-3 E3 RC helicopter tail and elevator linkage. It is intended for routine servicing or to replace a worn shaft discovered during pre-flight checks.

Fitting is straightforward with standard model-care tools; take care to align control linkages and confirm the elevator has free, unrestricted movement after installation. Re-torque retaining hardware and inspect link pins for secure fit before powering the model.

Swapping a fatigued elevator shaft helps restore consistent control feel and reduces unwanted tail play. After installation, set the neutral position and run small servo throws to confirm there is no binding at full travel.