Eagle I-Type Lever A Replacement Linkage - HI0404627 by Hirobo  [HI0404627]

Direct-Fit I-Type Lever for Eagle/Freya Family

The Hirobo HI0404627 I-Type Lever A is a direct-fit replacement control linkage component made for the Eagle family and compatible models. It replaces worn or damaged I-Type levers to bring back consistent link movement in the rotor control system.

Fitting is simple for those used to helicopter linkages: detach the old lever from the ball joint or linkage arm, install the HI0404627 in the same orientation, and secure the original fasteners. Cycle the servos slowly through their range at low throttle to confirm smooth travel and to eliminate any binding before flight.

As a precision connection point the lever can reveal small alignment or wear issues that cause play or non-linear response. After installation check ball link seating, measure end-to-end travel on the control rod, and trim servo endpoints as needed to maintain a neutral, symmetric control throw.