Eagle Freya Servo Stay H=12mm Mount for Precise Servo Height - Hirobo HI0414484  [HI0414484]

Mounting bracket for Eagle Freya servos

This Hirobo HI0414484 servo stay is an RC-scale mounting bracket that sets the servo mounting height at 12mm. It acts as a rigid support for a helicopter servo, keeping the servo axis aligned with the airframe mounting points to preserve predictable control link geometry.

Fit this part when you need repeatable servo positioning, such as replacing a worn bracket or matching servo centers during setup. The item is listed under Eagle Freya helicopter parts, so always confirm the mounting pattern on your model before fitting.

Installation notes: position the stay so the servo output spline lines up with the control linkage, reuse the model's original mounting holes when possible, and tighten fasteners in stages to avoid shifting the bracket. This component is intended as an accessory for RC helicopters only.