This replacement mixing arm is supplied as a control linkage component for the Hirobo EAGLE EX family. It sits between cyclic and collective inputs and the swashplate linkage, providing the mechanical joint used when installing or repairing rotor mixing geometry.
When fitting the mixing arm, inspect the mating pivots and linkages for free movement and minimal play before final assembly. Typical fitment involves aligning the arm with the swashplate and fastening it to the control link with the original hardware; keep any original washers or spacers to preserve the intended lever ratios and throw.
Small setup errors at installation can change collective-to-cyclic feel, so secure all fasteners, confirm link geometry, and perform a hover check at low power to verify correct movement before a full-power flight.
A straightforward service replacement for Eagle-series helicopters, useful when the original mixing arm shows wear or when performing fitment work on swashplate geometry.
Copyright © 2008-2026 rcjaz.ca All rights reserved
