DZ70 Push Rod Replacement - YSG7040 for YS Engine  [YSG7040]

YS ENGINE PUSH ROD DZ70 #G7040
Price:
CAD$7.98
Brand:
YS Engine
Model:
YSG7040
GTIN:
4562101335956
Condition:
Brand New
Write a review

Replacement push rod for YS DZ70

This YSG7040 push rod is a service replacement for YS Engine DZ70 glow engines, supplied as a single part to restore correct valve actuation in the valvetrain linkage.

Fit this push rod when the original shows wear, bending, or excessive endplay that alters valve timing. It transfers cam or rocker motion to the valve lifter, so straightness and correct fit are important for reliable running and accurate valve clearance during setup.

Installation is straightforward at a component level: remove the rocker and valve linkage retaining hardware, withdraw the old push rod and replace with the new YSG7040, then reassemble and verify valve clearance and movement through the full travel range. After installing, check for smooth operation without binding and confirm clearances before running the engine.

Compatibility: Compatible with DZ70 series YS RC glow engines.

How can I confirm this fits my DZ70?

Check the part dimensions and match the push rod end configurations to your engine's valve linkage. This YSG7040 is produced as a like-for-like service replacement for the DZ70 family.

Any installation tips to avoid binding?

When fitting, ensure rocker studs and retainers are free of debris, insert the push rod straight, and rotate the engine slowly by hand to check full travel and that nothing binds before final reassembly.

What should I inspect during routine checks?

Inspect for straightness, wear at the ends where contact occurs, and any surface fatigue. Replace the push rod if any bending or excessive end play is present to maintain accurate valve timing.

Copyright © 2008-2026 rcjaz.ca All rights reserved