DRIFT PACKAGE Steering Blocks, Graphite-Molded for DP-Series - SD-415SG by Yokomo  [SD-415SG]

Yokomo SD-415SG steering blocks for DRIFT PACKAGE

The SD-415SG steering block is an RC-scale replacement produced in a graphite-molded style that preserves the silhouette of the stock drift package knuckles. It is intended to be lighter than some alloy options so the reduced mass at the steering knuckle sharpens steering response and feedback for drift setups without altering suspension geometry.

This part is supplied as a drop-in steering block pair for compatible DRIFT PACKAGE chassis. Fitment retains the original kingpin locations and mounting points so servo travel, ackermann and tie-rod lengths stay compatible with common drift steering linkages. Compared to Trail 1 steering blocks, the graphite-molded SD-415SG gives a more immediate steering feel useful when refining toe and steering throw for controlled slides.

Installation notes: remove the original left and right steering blocks, transfer kingpin hardware and bearings if reusing them, then install the SD-415SG blocks using the factory screws and spacers. Double-check kingpin spacer placement and torque on the steering link bolts during reassembly, and verify toe and steering endplay on the bench before running on track.