Drift Package DP-DPR Front Shock Tower for Upper A Arm - YOKD156F by Yokomo  [YOKD156F]

DP-DPR front shock tower overview

This front shock tower is the Yokomo YOKD156F replacement part intended for use with the Drift Package DP-DPR upper A arm configuration. The copy highlights fitment, expected installation steps, and how the tower integrates into front-end tuning without asserting material specifics beyond the manufacturer's listing.

Use this tower to restore or reconfigure front suspension geometry when setting up a DP-DPR based drift layout. It lines up with the upper A arm mounting points specified by the DP-DPR package and provides the attachment interface for front shocks and upper linkages.

Installation generally involves removing the original tower, moving shock assemblies and link connections to the new tower, confirming bolt thread engagement and clearances, and checking steering and camber after reassembly. Verify alignment at ride height and re-tighten fasteners after an initial test run to ensure secure fitment.

From a setup perspective the tower acts as the shock top mount platform and can change shock angle and effective motion ratio at the front, so swapping towers is a common step when adjusting bump steer, roll center, or shock mounting geometry on 1/10 scale drift cars using the DP-DPR layout.

For hobbyists running a DP-DPR drift package, the YOKD156F delivers the correct interface for upper A arm setups and a straightforward route to restoring or altering front mounting geometry; inspect fasteners and confirm fitment during installation to preserve predictable handling.