DRB/DIB Front Suspension Arm 1mm Aluminium (Black) - YOKTS2142 by Yokomo  [YOKTS2142]

Aluminium front arm for DRB and DIB chassis

The Yokomo YOKTS2142 is a machined aluminium front suspension arm designed for RC touring car setups that use the DRB or DIB chassis platforms. As a direct RC-scale replacement it gives a stiffer mounting point for front suspension parts and is intended for hobby use only.

This unit is supplied as a single-piece aluminium arm with a 1mm profile and black anodized finish. It installs into the front suspension assembly to adjust geometry and steering response; installers should confirm compatibility with their DRB or DIB hub and mount hardware before fitting. The arm aids tuning tasks such as roll stiffness and toe control when used with standard linkages and hardware.

Installation notes: check existing mounting pins and ball studs for wear, confirm correct orientation to the hub carriers, and tighten fasteners to your chassis manufacturer's torque recommendations. Use threadlocker on metal fasteners where your setup requires it. This component is for 1/10 scale RC touring cars and is not suitable for full-size vehicles.

Choose this arm when you need a direct aluminium replacement for front suspension tuning on DRB or DIB touring car chassis; combine with suitable hardware and setup changes to reach the desired handling behavior.