DPR Front Upper A Arm Hinge Pins - Yokomo D-156P  [D-156P]

DPR front upper A-arm hinge pins

This RC-scale hinge pin set replaces the pins fitted inside the front upper A arm on DPR chassis. The package contains 2 pcs intended as direct replacement parts to address wear or damage in the upper arm pivot area.

Compatibility is restricted to the DPR variants listed below, and the part's purpose is to restore secure pivoting and consistent suspension geometry at the front upper A arm. Replacing worn pins helps maintain alignment and predictable suspension action for setup and track use.

Installation overview: remove the upper A arm from the chassis, slide out the worn pins, refit any bushings or spacers in their original order, then insert the new pins until fully seated. After fitting, cycle the suspension through its travel to confirm smooth movement and secure retention; if excessive play remains, inspect and replace as required.