DP-DPR Right Aluminum Steering Bell Crank - D-128R by Yokomo  [D-128R]

Yokomo D-128R Aluminum Steering Bell CrankR for DP-DPR
Price:
CAD$11.13
Brand:
Yokomo
Model:
D-128R
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - DP-DPRA category
Write a review

Right-side bell crank for DP-DPR

The Yokomo D-128R is the right-side aluminium steering bell crank specified for the Drift Package DP-DPR chassis. It is an RC-scale replacement machined from anodized aluminum to resist corrosion and preserve accurate pivot fitment.

Fit this D-128R when you need a direct swap for the right steering arm on DP-DPR builds or when moving parts among the DP series variants. It retains factory mounting geometry so it uses the same screw points as the original right-side aluminium bell crank.

Installation notes: the part is designed to use the chassis original hardware and mounting pattern; after installation check steering linkage alignment and verify pivot play at the axle and bell crank interface. In tuning terms, swapping a worn plastic bell crank for this aluminium unit can stabilize steering input and help keep geometry consistent during drift runs.

Compatibility

  • DP-DPR
  • DP-DPMS
  • DP-DPRA
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is the D-128R built just for the right side of the chassis?

Yes. The D-128R is formed to match the right-side pivot geometry and is intended as the right steering bell crank.

Will this part install on DP-DPMS or DP-DPRA models?

It is compatible with DP-DPMS and DP-DPRA, sharing the same mounting pattern as the DP-DPR right-side bell crank.

Do I need new screws or fasteners to fit it?

Typically no. The part is made to accept the original chassis hardware, but always confirm fit and torque after fitting.

Copyright © 2008-2026 rcjaz.ca All rights reserved