DP-DPR Left Aluminum Steering Bell Crank D-127L for DP-DPR by Yokomo  [D-127L]

Left-side aluminum bell crank for DPR-series

This is the left-side aluminum steering bell crank designed for the Drift Package DPR family of chassis. It serves as the left steering bell crank in the steering linkage between the servo and tie rods on compatible DPR-series models.

Compatibility is specific to the DP-DPR chassis and the variants listed as supported, including DP-DPMS and DP-DPRA. Use on model vehicles only and compare dimensions with the original part to ensure correct fit before final installation.

Installation is straightforward for anyone familiar with DPR-series steering assemblies: remove the factory left bell crank, confirm alignment with the servo output arm and steering linkage, then fit the D-127L in the same orientation as the original. Inspect existing ball bearings and fasteners for wear and tighten components to the vehicle's recommended torque using suitable hex drivers.

For setup and tuning the D-127L functions as a direct left-side replacement and helps keep steering geometry consistent during repairs or baseline adjustments. It is intended as a service part to preserve steering symmetry rather than as a performance upgrade.