DIB 275mm Rear Drive Belt 161T - Yokomo YOKIB483B1  [YOKIB483B1]

Yokomo IB-483B1 - FCD x 2.0 Rear drive belt for DIB 275mm Long wheel base (161T)
Price:
CAD$13.67
Brand:
Yokomo
Model:
YOKIB483B1
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - DIB category
Write a review

DIB 275mm Rear Drive Belt Details

This belt is an RC-scale replacement part intended for the DIB 275mm long wheel base chassis, specified as a 161T rear drive belt. The FCD x 2.0 marking identifies the belt design variant and is used here as the technical attribute for selection and setup.

Fitment is limited to the stated DIB 275mm long wheel base configuration; verify pulley alignment and tooth engagement before final assembly. Typical installation requires access to the rear drive area, removal of the old belt, and careful routing to ensure even tension across the 161 teeth.

In tuning and maintenance, this belt is a service-level consumable that affects drivetrain feel and efficiency. Replace when tooth wear, fraying, or inconsistent tracking appear, and recheck mesh and tension after the first few runs.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this belt fit other wheelbase lengths?

Compatibility is focused on the DIB 275mm long wheel base. Measure your chassis spacing and pulley locations to confirm fit before purchase.

What basic tools help for a clean replacement?

Basic hand tools to access the rear drivetrain, small hex drivers and needle-nose pliers are usually sufficient; a simple tension gauge or a feeler method helps set correct belt tension.

When should I recheck belt tension after installation?

Check tension and tooth engagement after the first run and again after a few heat cycles or short sessions to ensure stable tracking and mesh.

Copyright © 2008-2026 rcjaz.ca All rights reserved