Concept 60 Tail Rotor Grip Linkage - H6054 by Kyosho  [KYH6054]

The Kyosho H6054 is an RC-scale tail rotor grip made for Concept 60 series helicopters. It links the tail rotor blade assembly to the tail linkage, helping keep alignment and passing control inputs cleanly from the tail servo to the rotor.

Designed for hobby rotorheads, this part is suitable to replace worn grips or to have on hand as a spare during maintenance cycles. The focus is on a secure linkage connection and consistent geometry so tail pitch response returns to the same baseline after servicing.

When fitting, confirm the ball or clevis seating, ensure the grip rotates freely without binding, and then verify the full tail pitch range. Small shims or slight linkage length changes may be needed when fitting into a tuned tail setup to preserve neutral tracking and control feel.

For upkeep, inspect pivot and link contact points for wear, keep fasteners torqued to spec, and replace the grip if any play appears that could harm tail precision. Remember this is an RC spare component and not for real-vehicle use.