Compact Honeycomb Ballast Plates Tungsten Copper - Arrowmax AM-950040  [AM-950040]

Compact Honeycomb Tungsten Copper Plates

This Arrowmax AM-950040 pack contains ten honeycomb-pattern tungsten copper plates, each weighing 2.8g, supplied for RC-scale setup and small-scale ballast tasks. The set is aimed at builders who need compact mass additions to tune balance without major chassis surgery.

On the workbench these plates let you make precise increments: add or remove single 2.8g pcs to adjust nose to tail balance or tweak corner behaviour. The honeycomb layout keeps the parts light in profile while concentrating mass where it affects handling the most.

Fitting is simple where loose ballast is accepted: common solutions include slipping plates into chassis pockets, using mounting trays, or fixing them with hobby-grade double-sided tape or adhesive pads; always verify clearance and secure each plate before running to prevent shift during use. Check servo linkages, suspension travel, and electronics positions to avoid interference after installation.

For tuners and scale racers wanting fine ballast steps, the AM-950040 plates deliver consistent 2.8g increments in a honeycomb form that suits iterative chassis balancing and handling tests.