CDR5000 Voltage Terminal Harness Cord - Futaba FU6A16801  [FU6A16801]

CDR5000 Voltage Sensing Harness

This Futaba FU6A16801 terminal harness cord provides an RC accessory to connect battery packs to a CDR5000 charger for voltage sensing. It acts as a dedicated voltage lead to route pack voltage to the charger without altering packs or the charger housing.

Made for use with the CDR5000 charger, confirm your charger model prior to fitting. The harness is a plug-in lead intended for voltage monitoring during charging, battery checks and bench setup tasks where a pack voltage readout is required.

Installation is straightforward: attach the harness to the charger terminal provided for voltage sensing and connect the matching battery connector to the pack’s voltage tap or main terminals as appropriate for your pack. Keep contacts clean and secure and avoid putting strain on the wire and terminals to ensure reliable readings.

In tuning and maintenance workflows the harness is helpful for quick pack voltage checks between runs, confirming cell balance values shown by the charger, and keeping the charger’s sensing path consistent when swapping batteries on the bench.