B-Max-2 Rear Hub Carrier Replacement - Yokomo YOKB2-415R  [YOKB2-415R]

B-Max-2 Rear Hub Carrier Overview

The Yokomo YOKB2-415R is a service replacement rear hub carrier designed specifically for the B-Max-2 1/10 touring chassis. It restores the connection between the wheel hub and the rear suspension upright, returning geometry to factory alignment after wear or damage.

Fit and installation: this component is produced as a direct replacement for the factory rear hub carrier on a B-Max-2 chassis and should install without modifying adjacent parts. During fitting, confirm the carrier aligns with the rear upright and that fastener holes match the chassis locations; use the correct hex driver and follow standard RC workshop procedures. Take care not to overtighten fasteners and inspect thread condition before final assembly.

Tuning role: replacing the hub carrier is a standard way to recover geometry or alter rear-end behavior if alternate offset carriers are available for the B-Max-2. On-track, the hub carrier affects camber and toe response, so perform small setup changes and test runs after replacement to refine handling.

Maintenance notes: inspect the carrier for signs of wear or bending during routine service, check associated bearings and wheel hex for play, and renew any worn hardware. Clean mating faces and remove debris before reassembly to ensure consistent alignment.