Blitzer Beetle Rear Suspension Arms JR-TASB02-LB (Light Blue) - upgrade for Blitzer Beetle / Stadium Blitzer / Stadium Thunder by Jazrider  [JR-TASB02-LB]

Light blue anodized rear suspension arms

This is an RC-scale aluminum replacement for the rear suspension arms used on Blitzer Beetle, Stadium Blitzer and Stadium Thunder models. The parts arrive in a light blue anodized finish and serve as direct replacement hop-ups for the rear arm assemblies on the listed chassis.

Compatibility is limited to the named models: Blitzer Beetle, Stadium Blitzer and Stadium Thunder. These arms take over the rear suspension role previously handled by the stock plastic arms, offering greater rigidity and improved wear resistance for repair or upgrade scenarios.

Installation uses the same mounting points as the original rear arms, enabling swap-in replacement without altering chassis geometry. Remove the factory rear arms, move any required bushings or hardware from the originals, then fit the aluminum arms to the rear suspension mounting points. After fitting, check full-travel movement and verify there is no binding.

From a setup perspective these aluminum arms are a simple tuning step: compared with stock plastic they increase stiffness and durability, which can produce a firmer rear-end feel and more consistent alignment under load. Introduce them alongside spring, damper and toe changes to observe handling differences incrementally.