Blitzer Beetle Front Aluminum Arms JR-TASB01-BK by Jazrider  [JR-TASB01-BK]

Aluminum Front Arms Built for Blitzer Beetle Chassis

This is an RC-scale aftermarket front suspension arm set intended for Blitzer Beetle, Stadium Blitzer and Stadium Thunder chassis. The parts are finished in black anodized aluminum and are presented as a direct replacement option where alloy arms are preferred for their stiffness and wear resistance compared with molded plastics.

Use and fitment: the arms are produced to match the front suspension mounting points of the named models so they can be used during routine maintenance or when updating a setup for track or bashing sessions. The component serves as a tuning item to alter front-end flex characteristics and feedback during cornering.

Installation notes: install using the vehicle's existing hardware where possible, check ball stud and hinge pin fit, and confirm steering geometry and toe after fitting. When testing, make incremental changes and assess handling before increasing ride harshness.

Tuning guidance: swapping to aluminum arms is typically paired with revised shock settings and roll center checks to balance the firmer arm behavior, aim for small adjustments to spring rate or damping rather than large leaps.