BD8 Front Steering Hub Carrier (graphite molded) - Yokomo B8-413GH  [B8-413GH]

BD8 Front Hub Carrier - Hard Type

The Yokomo B8-413GH is a hard-type front steering hub carrier molded with a graphite-containing resin compound engineered for BD8 series touring cars. The chosen compound raises component rigidity over standard plastic carriers, which sharpens initial steering response and helps preserve stability during fast cornering.

This product is supplied as one piece per side, left and right. Fitment targets BD8-compatible platforms; confirm your chassis code before fitting. The carrier replaces the stock front hub carrier to change steering feel and front-end response without altering suspension geometry.

Installation notes: the carrier mounts in the same location as the original BD8 front hub carrier and uses the existing fasteners and bearings from the standard assembly. After installation check alignment and bearing preload, and verify there is no interference with the servo horn or tie-rod travel before running.

Tuning role: fitting this harder, graphite-reinforced carrier can reduce flex under steering loads, delivering crisper turn-in and more predictable behavior through sustained cornering. Use it alongside tyre selection and suspension tweaks as part of a front-end setup progression to refine turn-in and mid-corner balance.