BD-7 Steering Bell Crank (1mm Longer) - B7-202S1 by Yokomo  [B7-202S1]

Yokomo B7-202S1 Steering bell crank for BD-7 (1mm long/with BB)
Price:
CAD$0.00
Brand:
Yokomo
Model:
B7-202S1
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Yokomo B7-202S1 steering bell crank for BD-7 tuning

The Yokomo B7-202S1 is an RC-scale steering bell crank built for BD-7 family chassis. The arm is 1mm longer than the standard BD-7 bell crank, a small change that sharpens initial steering response by altering the leverage and initial geometry.

Press-fit ball bearings are used in the support section to cut pivot friction and keep steering feel consistent across a run. Because the bearings are pressed in at the factory, the part arrives ready to swap into the stock location with minimal alignment work.

Choose this bell crank when you want a measured increase in steering bite without changing tie-rod lengths or servo endpoints; it serves as a tuning detail rather than a full steering redesign.

Compatible Models

  • MRTC-BD716O
  • MRTC-BD716S
  • MRTC-BD715B
  • MRTC-BD715O
  • MRTC-BD715S
  • MRTC-BD716
  • MRTC-BD716H

For BD-7 chassis tuning this bell crank provides a compact, low-impact way to sharpen initial steering feel while keeping installation straightforward.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How can I confirm this fits my exact BD-7 chassis code?

Check your chassis code against the compatibility list above. If your BD-7 variant matches one of the listed codes, the B7-202S1 is designed to fit as a direct replacement for the stock bell crank.

What handling change should I expect from the 1mm longer arm?

The extra millimetre slightly increases initial steering bite, producing quicker turn-in. It shifts the initial leverage relationship without creating a large mid-corner change.

Are the ball bearings included and fitted already?

Yes. Bearings are press-fitted into the support section at supply, so the part is delivered with bearings installed and aligned for direct fitment.

Will I need to change my endpoints or tie-rod lengths after fitting this?

Major changes are usually not required. After installation, verify steering endpoints and toe and make only small trims if needed to restore your preferred steering balance.

Copyright © 2008-2026 rcjaz.ca All rights reserved