Axial Yeti XL Stainless Steel Steering Post YTL048AS by GPM  [YTL048AS]

Stainless steel steering post for Yeti XL chassis

This stainless steel steering post is an RC-scale replacement part for the Axial Racing Yeti XL platform. It provides a metal upgrade at the steering post to increase rigidity and service life compared with common stock materials.

The part installs into the same mounting location as the stock steering post on the Yeti XL chassis, keeping steering geometry intact while cutting down flex at the linkage pivot. Swapping in the metal post helps the steering stay aligned under heavier loads and during prolonged trail use.

Fitting is straightforward: disassemble the front steering assembly, remove the factory post, and refit using the chassis mounting points and existing fasteners. After installation, check steering travel and centring and confirm there is no binding through full articulation; make small linkage adjustments if required.

Tuning advice: treat the post as an increase in steering stiffness. Pairing a metal post with firmer linkages and an appropriately rated servo will sharpen feedback, while softer linkages preserve more compliance over rough ground.