Axial Yeti XL Spring-Steel Steering Tie Rod YTL047SP by GPM  [YTL047SP]

Axial Racing Yeti XL Spring Steel Steering Tie Rod With Plastic Ball Ends(AX31033) - 1pr set - GPM YTL047SP
Price:
CAD$16.44
Brand:
GPM
Model:
YTL047SP
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Reinforced steering link for Yeti XL

This steering tie rod is a replacement link made for the Axial Racing Yeti XL platform and is listed as AX31033, supplied as a 1 pr set. The load-bearing element is spring-steel and each end uses a plastic ball to allow pivoting at linkage joints while avoiding metal-to-metal contact.

The part functions as the steering link between the servo linkage and the steering knuckles, providing a direct adjustable connection for tuning toe and centring. Spring-steel construction adds elastic recovery after impacts, helping the rod spring back toward its original shape following typical off-road bends.

Installation is simple: remove the existing tie rod pair, fit this replacement set, check ball-end seating and free joint movement, then confirm steering geometry. Inspect the plastic ball ends regularly for play and replace the set if the joints show wear to retain accurate steering response.

What comes in the box with this part?

The item is supplied as a single pair of steering tie rods intended to replace the factory pair on the Yeti XL.

Can I use this on other Axial models?

This part is produced for the Axial Racing Yeti XL platform and is listed as AX31033; fit it where that part number or compatible geometry applies.

How do I check the ball ends for wear?

Check for side-to-side play at each ball joint, clean out dirt and grit, and replace the tie rod set if any looseness appears to keep steering crisp.

Copyright © 2008-2026 rcjaz.ca All rights reserved