Axial Yeti XL Aluminum Front Knuckle Arms YTL-25000 by Jazrider  [YTL-25000]

Aluminum front knuckles for Yeti XL

The YTL-25000 front knuckle arm set is an RC-scale replacement designed specifically for Axial Yeti XL steering assemblies. Machined from aluminum, these components give a firmer mounting point than stock plastic parts to help reduce flex under load and maintain suspension geometry during trail runs or bashing sessions.

As direct-swap replacements where compatible, the arms provide a more stable pivot for the front suspension and can influence steering feel and caster consistency. The set includes left and right pieces; confirm fitment with your Yeti XL hub carrier and linkage layout before fitting.

Installation notes: the knuckle arms attach to the existing front hub carriers and use the stock fasteners and linkage locations on standard Yeti XL models. Trimming of adjacent components is generally not required for standard setups, but always check wheel and C-hub clearances after installation. Periodic inspection of mating pins and bearings is recommended to keep operation smooth.

Compatible Models

• Axial Yeti XL

Use these knuckle arms to cut front-end flex and provide a firmer platform for steering setup changes; keep hardware torque and bearing condition within manufacturer recommendations to avoid premature wear.