Axial Yeti Steering Tie Rod and Aluminium Servo Horn for 25T Spline YT16025 by GPM  [YT16025]

Yeti steering upgrade summary

This upgrade pairs a spring steel anti-thread tie rod with an aluminium servo horn designed for Axial Racing Yeti steering systems that use a 25T spline output shaft. The parts are intended as direct replacement or hop-up components for steering linkages and the servo output on Yeti rock racer style models.

Design purpose: the spring steel tie rod resists thread stripping and wear during repeated steering loads, while the aluminium horn gives a firmer interface at the servo spline. Together they improve steering consistency and hardware longevity under normal RC use, without implying specific performance gains.

Fitment and setup: the servo horn fits a 25T spline output shaft and installs in place of the stock horn. The tie rod attaches between the horn and steering knuckle or bellcrank depending on the Yeti chassis layout; installation requires common RC tools and standard trim checks. Confirm spline match and clearances before final tightening, then test steering travel at low throttle to ensure smooth operation.