This aluminium front lowerarm is a direct aftermarket replacement made for the Axial Yeti Rock Racer platform, supplied as a 1pr set. It is a tougher alternative to the stock plastic arm and gives more consistent flex and impact resistance for RC rock racing and trail running.
The part is intended for hobbyist use and focuses on fitment and front-end tuning: it secures knuckles and steering links and alters roll centre and camber response when used with standard Axial suspension geometry. Installation needs common RC hand tools and basic front upright disassembly; check pivot pin diameters and ball stud positions after fitting to keep the intended handling balance.
When adjusting the front end, this lowerarm suits users changing ride height, shock droop, or toe and camber via the existing mounting holes. Due to the higher stiffness compared with plastic arms, expect altered feedback and contact behaviour that should be validated on a short test run before serious driving.
Use this arm as a replacement or hop-up when you want steadier front-end behaviour and greater crash resistance than stock plastic, and always confirm alignment and clearances during installation.
Copyright © 2008-2026 rcjaz.ca All rights reserved
