Axial Yeti Rear Anti-Roll Mount YT312 by GPM  [YT312]

Rear anti-roll and cage attachment for Axial Yeti

This 9pcs set addresses the rear anti-roll linkage and cage attachment points used on Axial Racing Yeti models in RC rock racing applications. The components are an aluminium aftermarket mount and a length of wire that replace or relocate the factory sway bar and cage anchors to enable controlled rear roll and a secure cage tie-in.

The parts are intended for hobby-grade chassis work and are presented as scale upgrade components for Axial Yeti vehicles. The kit supports three functions: a stiff mounting point for the rear sway bar, a secure location to fasten cage wiring or supports, and small, reversible tuning steps to alter rear roll resistance without changing suspension geometry.

Installation uses the existing rear mount points on the Yeti chassis. Typical steps include removing the stock mount hardware, positioning the aluminium mount in the factory location, routing and fastening the supplied wire for cage attachment, then checking suspension travel and clearances. Basic hand tools and a hex driver are normally sufficient, but precise torqueing and checks for binding are advised.

The product is intended for tuning and adjustment rather than structural modification. Hobbyists fit this mount to fine-tune rear anti-roll stiffness and to secure cage connections for trail and rock racing use, while keeping the change reversible so the original setup can be restored.

This aluminium rear sway bar and cage mount set is a compact aftermarket option for Axial Yeti owners who want controlled rear roll adjustment and a reliable cage attachment method while keeping installation reversible and using standard tools.