Axial Yeti Aluminum Servo Saver Set - YT-25007-GU by Jazrider  [YT-25007-GU]

Machined Aluminum Servo Saver for Axial Yeti

This machined gunmetal servo saver is an RC-scale replacement produced by JAZRIDER for the Axial Yeti chassis. It swaps out common plastic servo saver parts for a machined aluminum assembly to cut steering-linkage flex and give a firmer connection between the servo output and the steering geometry.

Installation is straightforward for hobbyists experienced with 1/10-scale rock racers: remove the stock saver, transfer reusable hardware and the servo horn, fit the aluminum saver to the servo spline, then verify centring and steering throw before final tightening. The unit is intended to work with the existing Axial Yeti steering linkage without modifying chassis members.

In tuning terms the aluminum saver reduces deformation under load to improve repeatable steering input and increases perceived steering stiffness versus softer stock pieces. That makes it a good upgrade when dialing in steering feel or when running higher-torque servos that can deform plastic parts.

Fit this saver when you want a more rigid servo-to-linkage interface on Axial Yeti kits; confirm servo spline compatibility and linkage geometry during installation and re-check centring after the first run.