Axial Yeti Aluminium Rear Cage Mount YT311A by GPM  [YT311A]

Sturdy aluminium rear mount for Yeti

This aluminium rear cage mount is an aftermarket replacement part for the Axial Racing Yeti platform, designed to restore or strengthen the rear cage mounting points on the RC rock racer. The component fits where chassis rails and mounting bushings match the Yeti cage geometry.

Its structural role is to create a rigid interface between the rear cage and the chassis rails, reducing unwanted movement under load and keeping body mounts aligned during hard runs. Aluminium offers better wear resistance than common plastics and helps the mount retain alignment after impacts.

Installation is straightforward for experienced hobbyists: remove the existing rear cage mount hardware, test-fit the aluminium piece to confirm hole alignment, then secure using the original screws or equivalent fasteners. Check thread engagement and use thread locker if that matches your usual maintenance routine. No specialized tools beyond standard hex drivers are needed for fitting.

For tuning work this mount helps keep repeatable rear cage position for suspension and body setup adjustments; it should be used as part of measured setup changes rather than as a cure for other damaged chassis parts.