Axial Yeti Adjustable Steel Main Shaft Kit YT237SAN by GPM  [YT237SAN]

Adjustable main shaft assembly for Yeti builds

This 7 pcs adjustable main shaft kit is an RC-scale upgrade intended for Axial Yeti platforms. The design pairs an aluminum 6061 T6 shaft body with hardened steel #45 cross shafts to keep rotating mass low while keeping critical contact surfaces in steel. The kit focuses on steering geometry and tuning flexibility rather than cosmetic change.

The axle assembly uses a universal swing shaft cross head to increase achievable steering angles for crawling setups, and the shaft is adjustable within the supplied range to suit different link lengths and suspension setups.

• Kit count: 7 pcs total.
• Included parts: 4*1 White Silicone O-Ring - 2 pcs, 4*2.5 White Silicone O-Ring - 2 pcs, M4*2.5*12 Screw Shaft - 2 pcs.
• Adjustable length range: 147-157 mm.

The aluminum shaft body reduces mass where suitable, while the hardened steel cross shafts provide wear resistance at the pivot points. Use this kit when you need a small, adjustable change to steering articulation or when replacing worn swing shaft assemblies on matching Yeti chassis.

Fitment is specific to listed Axial Yeti models, check link geometry before final installation and verify the adjustable range matches your current link lengths.