This 18-piece aftermarket damper set is made for Axial Yeti 1/10 scale cars and is intended as a direct-fit suspension upgrade for rally-style onroad tuning. The units are hand-assembled to help lower ride height and refine damping for flatter, faster onroad rally performance.
Key mechanical measurements supplied by the manufacturer include a front length of 86mm and a rear length of 110mm, each measured center-to-center at the ball ends. The dampers have a 12.8mm cylinder diameter, a 4mm shock shaft, and a 2mm spring coil length. They are oil-filled with adjustable compression and preload so drivers can dial rebound and ride height to suit different surfaces and driving styles.
Installation notes: these dampers fit standard Axial Yeti ball-end mounting points and use common fastener sizes referenced by the maker. When swapping dampers, check lower mounting pins and springs for wear, bleed trapped air from the oil chambers after assembly, and test with incremental oil weights and preload changes to find the preferred setup.
Suited to hobbyists looking to tune ride height and damping for rally onroad courses with the Axial Yeti 1/10 platform; start with conservative oil weights and adjust preload to match track conditions.
Copyright © 2008-2026 rcjaz.ca All rights reserved
