This is an RC-scale aluminum upper linkage set made to fit Axial-based crawler chassis. The red anodized links are supplied as a 4pcs pack and replace the stock plastic arms to add rigidity at the upper suspension positions. The parts are intended for the listed Axial platforms and act as a direct hop-up to refine suspension geometry, roll center, and resistance to wear.
Installation notes: these links install in the upper link positions on the specified Axial chassis and use the existing ball ends or mounting points on the stock link mounts. When fitting, confirm ball-end spacing and thread engagement on the current hardware, and verify full suspension travel through the motion arc before final tightening.
Fit these links when you need a firmer upper link on crawler builds to limit lateral flex and preserve suspension geometry; always check fitment before heavy use.
Copyright © 2008-2026 rcjaz.ca All rights reserved
