This matched 2-piece aluminium steering link set is a direct replacement for the plastic rods used on Axial Wraith models, designed to reduce end-of-link flex and provide a firmer mechanical connection between the servo horn and steering knuckles.
The parts use a corrosion-resistant aluminium finish and are balanced to keep weight low while improving durability for everyday trail and rock crawling use. Supplied as a left/right pair to preserve steering geometry when both sides are replaced.
Installation is straightforward for anyone comfortable with basic steering maintenance: remove the original links, confirm ball stud and rod-end sizes, fit the aluminium links and confirm free movement through full suspension travel. Take care not to over-torque mounting hardware to avoid binding the joints.
Tuning notes: replacing plastic links with aluminium helps cut unwanted flex under load, stabilising steering input during aggressive manoeuvres and when you are adjusting servo endpoints or steering rates. Re-check tie-rod length and toe settings after fitting to retain the intended handling balance.
Copyright © 2008-2026 rcjaz.ca All rights reserved
