This aluminum hex wheel hub is a scale RC accessory intended to alter wheel offset on Axial Wraith setups. The part increases wheel spacing by 5mm compared with the standard hex location, providing a simple method to adjust track width and tire clearance without changing suspension geometry.
Constructed from black anodized aluminum, the hub focuses on dimensional stability and repeatable fit. In practice this item is used where small changes in wheel position help with obstacle clearance, tyre alignment, or to tune handling on crawling and slow-speed trail sections.
Installation is straightforward for technicians familiar with wheel hex components: remove the wheel, swap the original hex for the wider hub, then re-secure the wheel using the vehicle's standard fasteners. Verify wheel centring and fastener torque after fitment, and confirm there is no interference with the suspension or bodywork.
Copyright © 2008-2026 rcjaz.ca All rights reserved
