Axial Wraith 14T Steel Motor Pinion WR9014TS by GPM  [WR9014TS]

Axial Racing Wraith Steel Motor Pinion (14T) - 1pc - GPM WR9014TS
Price:
CAD$5.39
Brand:
GPM
Model:
WR9014TS
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

14T Steel Pinion for Wraith Drivetrains

This steel 14-tooth motor pinion is intended for use on Axial Wraith platforms and supplied as an aftermarket replacement (WR9014TS). It meshes tooth-for-tooth with the model's spur gear to deliver the final drive ratio expected when a 14T pinion is fitted.

Fit this pinion to replace worn teeth or to fine-tune drivetrain gearing on Wraith-compatible rigs. Steel construction gives greater resistance to wear and repeated installation compared with softer pinions, making it a practical choice for trail and crawl setups.

Installation notes: align the pinion with the spur gear to obtain correct mesh, verify axial position on the motor shaft, and secure using your existing pinion retention method. After installation, check for smooth rotation and correct backlash before running the model.

Will this pinion fit a standard Axial Wraith gearbox?

Yes. This pinion is intended for Axial Wraith drivetrains where a 14T motor pinion is specified. Confirm your motor shaft diameter and mount type before fitting.

How does a 14T pinion change performance?

The 14-tooth count changes the final drive ratio relative to the spur gear; lower tooth counts tend to increase torque at the wheels while reducing top speed, and higher counts do the opposite.

What checks are needed after installation?

Verify proper gear mesh and free rotation, confirm the retention fastener is secure, and run a short test to check for binding or excessive backlash.

Copyright © 2008-2026 rcjaz.ca All rights reserved