This 12-tooth steel motor pinion is a direct replacement part for Axial Wraith setups, supplied as 1 pcs. It is intended for adjusting final drive ratios where small changes in gear count alter acceleration and low-speed control.
The forged steel profile and tooth form focus on repeated mesh durability, making the 12T option useful when you want stronger low-end response at the expense of peak speed. Check the pinion and spur engagement regularly for wear.
Fitting tips: position the pinion so the set screw seats squarely on the motor shaft, align side-to-side with the spur gear, and confirm proper clearance under realistic load. Perform a low-speed test run to listen for noise and check for heat before full-throttle use.
Supplied: 1 pcs, steel 12T motor pinion, single-piece pack.
Copyright © 2008-2026 rcjaz.ca All rights reserved
