AXIAL SMT10 Steel Front and Rear Bevel Gears SMJ1200 by GPM  [SMJ1200]

SMT10 steel bevel gear upgrade

This 2 pcs bevel gear set is a scale replacement for AXIAL SMT10 chassis, catalogued as SMJ1200. Machined from hardened steel, the pair is intended to replace worn factory bevels and return dependable drivetrain engagement on rock racing and monster-style SMT10 builds.

The kit includes one front and one rear bevel gear made to work with the vehicle's existing gearbox and bearings. Installation typically involves removing the original bevels, fitting the new steel gears with correct mesh and bearing alignment, and rotating the driveline by hand to confirm smooth operation before full use. These gears preserve the original gear ratio and are aimed at consistent engagement rather than altering motor requirements.

Tuning notes: verify pinion and spur alignment, inspect bearings and hex fits for wear, and use a light gear-safe lubricant on mating surfaces to reduce initial break-in wear. Periodic checks for pitting or deformation will help maintain long-term reliability.

Fit these two steel bevel gears to replace worn components on compatible AXIAL platforms, confirm mesh and bearing condition during installation, and schedule regular inspections to keep the driveline running smoothly.