This aluminium upper chassis link is a direct-fit replacement for AXIAL SMT10 platforms, supplied as a matched front and rear pair to assist chassis tuning and repair. The parts replace standard plastic links to give a firmer mounting point for suspension geometry adjustments without implying any real vehicle application.
In service, the aluminium links help keep camber and roll centre more consistent under load, making them useful when fine-tuning handling balance on Yeti and SMT10 Monster Jam models listed below. The design targets repeatable alignment and reduced flex versus stock non-metal links.
Fitting is straightforward for hobbyists comfortable with basic chassis work; the parts use common fasteners and a 3mm lock nut where required. Avoid over-torquing into composite or alloy mating points and use a suitable thread locker on steel-to-aluminium joints when finalising the setup.
Small hardware supplied from the original packing is included to fit the links, so verify quantities before installation and reuse any existing washers or spacers from your chassis as needed.
Copyright © 2008-2026 rcjaz.ca All rights reserved
