AXIAL SMT10 Aluminium Front/Rear Axle Housing MJ012 by GPM  [MJ012]

Aluminium axle housings for SMT10 service and tuning

This aluminium front and rear axle housing replaces the standard plastic housings on AXIAL SMT10 platforms to restore axle alignment and support drivetrain bearings and shafts. The part is intended for scale short-course and trail models where improved rigidity and repeatable axle geometry help with setup and maintenance.

Fitting typically requires partial axle and gearbox disassembly, inspection of seals and bearings, and secure re-torquing of fasteners to the vehicle's recommended values. Use the housing to replace worn components or as part of a modest drivetrain upgrade to reduce flex under load.

During installation confirm bearing inner diameters and correct shaft seating, check clearance across suspension travel, and verify driveshaft engagement with the gearbox output. Make incremental setup changes and test drive to assess handling and wear rather than assuming instant improvements.

Use this aluminium housing as a direct replacement or integrated into a targeted driveline upgrade for AXIAL SMT10-scale rigs; confirm fit and bearing sizes before final assembly.