This is an RC-scale replacement steering knuckle carrier and C-hub set engineered for Axial 1/6 SCX6 Jeep models. The red anodized aluminum parts take the place of standard plastic components to create a firmer mounting point for steering knuckles and C-hubs, aiming to cut down flex under load and maintain steering geometry during crawling and trail driving.
Fitment targets the Axial SCX6 1/6 Jeep chassis family, offered as an aftermarket upgrade for hobbyists who want metal suspension parts. Installation involves removing the stock carriers and C-hubs and fitting the aluminum replacements in the original mounting positions; check alignment and full steering travel after installation to prevent binding.
From a tuning perspective, swapping to aluminum carriers changes system stiffness and steering response. Expect firmer feedback and less deformation on impacts, which can affect toe and caster under load. Perform alignment checks and small adjustments to steering trim and suspension settings to integrate these parts into the vehicle setup.
These aluminum carriers and C-hubs provide a durable alternative to stock plastic parts for the Axial SCX6 1/6 Jeep lineup, helping reduce flex and preserve steering geometry; always verify fit and inspect during installation.
Copyright © 2008-2026 rcjaz.ca All rights reserved
