This RC-scale front bumper mounting part fits the Axial 1/6 SCX6 Jeep platform and is supplied as model JR-SCX605-TI. The component is aluminum with a Titianum finish and is intended as a direct front bumper mount or a reinforcement point on scale SCX6 builds.
The mount secures the front bumper assembly and helps keep alignment under load during scale crawling or trail runs. The design emphasizes fit and rigidity over decorative use and suits hobbyists seeking a metal replacement for a stock plastic mount or a tuned front-end mounting location for accessory bumpers and recovery points.
Installation notes: the part is made to align with SCX6 front mounting points, so standard RC hand tools such as a hex driver set are typically sufficient. Verify existing bumper hardware and holes on your chassis match the mount before installation, and use appropriate thread-lock or lock washers where recommended for metal-to-metal fastenings in RC applications.
For scale SCX6 builds where a metal front bumper mount is preferred, this aluminum part provides a straightforward replacement or upgrade to improve front-end rigidity and mounting stability.
Copyright © 2008-2026 rcjaz.ca All rights reserved
