Axial SCX6 7075 Aluminum Steering Servo Arm - JR-SCX607-TI by Jazrider  [JR-SCX607-TI]

7075 alloy steering arm for Axial SCX6

This steering servo arm is made for Axial SCX6 1/6 Jeep models and is sold under the JR-SCX607-TI part number. The alloy replacement stiffens the connection between the servo output and tie-rods for more precise trail steering compared with stock plastic arms.

Compatibility targets Axial SCX6 Jeep JLU Wrangler 1/6 scale setups; check the servo spline pattern and hole spacing on your existing servo before fitting. The component is CNC machined from 7075 aluminum to balance strength and weight for RC trail use.

Fitting advice: remove the original arm, align spline engagement, fit the new arm on the servo spline and secure with the factory retaining screw or an appropriate fastener. After installation verify full travel and steering geometry to ensure toe and tie-rod clearances are correct. This is an aftermarket RC steering linkage part and is not for full-size vehicles.