AXIAL SCX10 Main Drive Shaft Pair F:123-133mm R:118-128mm SCX037SA by GPM  [SCX037SA]

Front and rear drive shafts for SCX10 applications

This replacement set supplies a matched front and rear main drive shaft pair for AXIAL Racing SCX10 scale crawlers. Each shaft blends steel at the spline interfaces with aluminium sections where appropriate to reduce rotating mass while maintaining spline wear resistance, and the set is supplied as two pieces for front and rear use.

Lengths are given to suit common SCX10 driveline layouts, stated as front 123mm-133mm and rear 118mm-128mm. These shafts transfer torque from the gearbox to the axles and will influence driveline stiffness and endplay. Before fitting, verify spline engagement, alignment and clearance to avoid binding or premature wear.

Fit this pair when you need direct replacement shafts that match common SCX10 front and rear length ranges and when you prefer a steel and aluminium balance in the rotating drivetrain parts.