Axial SCX10 III Wheel Hex Adapters +3mm Aluminum - SCX3010/+3M by GPM  [SCX3010/+3M]

Aluminum wheel hex adapters for SCX10 III platforms

This aftermarket kit provides aluminum wheel hex adapters designed for Axial platforms, made to link the front CVD and rear drive shafts to 1.9-scale wheels on trail and scale rigs. The adapters add +3mm to the hub, widening track and reducing the gap between wheel and hub to improve lateral stability on technical sections.

The set contains 4pcs aluminum hex adapters and 4pcs stainless steel screw shafts M3.5x2x11.8, original part number AXI232018. The adapters are machined from 6061 T6 aluminum to balance low weight with tensile strength; they are intended for RC-scale use only.

Installation notes: these adapters replace the stock wheel hexes and use the supplied stainless shafts for retention. Check spline alignment between wheel and CVD, torque screws to proper thread engagement, and verify wheel runout after fitting. Use the correct hex driver size for the supplied screws and recheck hardware after initial runs.